Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

CCME uses at Hub with Remotes Registering over WAN (Codecs)

Is there a way to set the Codec when a call is placed using CCME and the phone is located across a wan? Since the Phones are registering to the Hub I am guessing the hub thinks it's a local phone and sets all calls to G.711. Would like the ability to change codecs accross the WAN so that it doesn't eat up so much bandwidth. ( Like G.729 or something.) Thank you

1 REPLY
VIP Purple

Re: CCME uses at Hub with Remotes Registering over WAN (Codecs)

You can set the preferred codec on a per phone basis using the "codec" command in ephone configuration. Take a look at the following look.

http://www.cisco.com/en/US/products/sw/voicesw/ps4625/products_configuration_guide_chapter09186a00806a7ffb.html#wp1056386

Hope this helps. If so, please rate the post.

Brandon

107
Views
0
Helpful
1
Replies
CreatePlease to create content