Any info out there on how the Peer Firmware Sharing feature works? I have seen the readme file and a couple of brief descriptions in phone admin docs but I was wondering if there was anything else with some more detail.
By default, Peer Firmware Sharing is not enabled. To enable peer firmware sharing for a few phones, enable Peer Firmware Sharing settings, from Cisco Unified Communications Manager, choose Device > Phone > Add New. Then, from the Phone Configuration window, choose Peer Firmware Sharing from Product Specific Configuration.
To configure Peer Firmware Sharing for many phones, enable Peer Firmware Setting in the Phone Template window of the Bulk Administration Tool. For details, see the Cisco Unified Communications Manager Bulk Administration Guide.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...