I don't think so because once the first number is called the call is connected and the second numbers digits are going to be inband in the audio. Just like if you called a bank and input you account number we would not write that in cdr.
Is possible to set up somewhere in CCM the option to have always out-of-band DTMF signalization from IP phone to gw, maybe then it would be possible to read the whole number in CDR. I want to resolve it because of billing soft, which will not be so strong if such a hole will exist in CCM. Then i bill only the first number which is less expensive than the second one.
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...