Is there any way to make the CFwdALL button "remember" the last number that was used as a destination? On our Nortel system once you enter the Call Forward destination it is remembered and all you have to do is push the button twice to activate. Getting requests from our users for the same functionality on the 79XX phones.
We still run Nortel as well along with CCM.I guess we are lucky that most of our users are so happy to receive the new Cisco phone that they quickly forget about what they once had.Most of them only ever CFWD to VM anyways, so when you show them that they can do this by simply pressing the CFwdALL Softkey and the Message key, they are more than happy! I think Brandons idea for people who might forward to Cell phones etc. is a good fit.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...