Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Change ATA186 from SCCP to H323 on CME

Hi there,

I'll begin by apologising for the broadness of the post, I really have no idea where to go with this.

We have CME7.0 with an ATA186 running SCCP and a fax machine off it. We're having major problems with the faxing so I need to change the image to H323 (or so I'm told).

I've copied the H323 image (ata18x-v2-16-1-030709a.zup) to the flash, defined it in TFTP, changed the load in telephony-service (without the .zup extn), but it won't upgrade. Am I missing something??

Also, there are no other h323 end points on this system. Do I need to do much to get it working over h323??

Thanks in advance,

Neil

1 REPLY

Re: Change ATA186 from SCCP to H323 on CME

Hi Neil,

Take a look at this procedure:

http://www.cisco.com/univercd/cc/td/doc/product/voice/ata/ataadmn/h32330ad/h3288apc.htm

Hope this helps!

JC Arias

199
Views
0
Helpful
1
Replies