Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Change the logo for a 7905/12

Do you know if the procedure to change the logo from the 7905 and 7912 phones is the same if those phones are registered in a callmanager 4.1(3) sr1 ????

I hope u can help me ... thanks

1 ACCEPTED SOLUTION

Accepted Solutions

Re: Change the logo for a 7905/12

Please see the Changing the Logo on the Cisco IP Phone LCD Screen section of the following administration guide. This guide is for CCM 3.2 and later so the procedure should work fine in 4.1(3)sr1.

http://www.cisco.com/en/US/partner/products/hw/phones/ps379/products_administration_guide_chapter09186a0080473876.html#wp1010905

Hope this helps.

Brandon

3 REPLIES

Re: Change the logo for a 7905/12

Please see the Changing the Logo on the Cisco IP Phone LCD Screen section of the following administration guide. This guide is for CCM 3.2 and later so the procedure should work fine in 4.1(3)sr1.

http://www.cisco.com/en/US/partner/products/hw/phones/ps379/products_administration_guide_chapter09186a0080473876.html#wp1010905

Hope this helps.

Brandon

New Member

Re: Change the logo for a 7905/12

It works, thanks.

Do u know how to restore the firmware on inoperables phones (7905/12) because when i tried to change the logo using a callmanager 4.1(3) without the service release 1 they didn't load again, the LCD screen remains empty and both leds are ignited. Each time when i connect them to a power inline switch they simply stay dead remaining in that status.

If u know how can i fix them i will appreciate a lot, thanks for all your help.

Re: Change the logo for a 7905/12

Try to remove the devices from CCM and let them auto-register. Please reference the field notice below.

http://www.cisco.com/en/US/products/hw/phones/ps379/products_field_notice09186a00804f1708.shtml

Thanks,

132
Views
0
Helpful
3
Replies
CreatePlease to create content