Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

changing 7912 ip phone displayed logo

Dear sir,

Please share with me how to change the above subject mentioned method for customize and change the logo display on our ip phone? Thank you.

Please advise.

3 REPLIES
Silver

Re: changing 7912 ip phone displayed logo

I think what you are looking for is under the phone configuration. Check the External Data Locations section for the IDLE field.

See this link for additional details. http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00803ed74c.html

Hope this helps.

Steve

Re: changing 7912 ip phone displayed logo

Please follow the new instructions below, step by step, in particular to step 7:

1. Download the SCCP Software Package Zip file.

http://www.cisco.com/cgi-bin/tablebuild.pl/ip_phone_client

2. Create the bitmap of the image to load to the phone

-The bitmap must be 88x27 pixels in size

-The bitmap must be black and white

-The bitmap must be saved as a image type

3. Convert the bitmap into a logo image using bmp2logo.exe

-bmp2logo x input_file output.logo

where x is an arbitrary number

-example: bmp2logo 10 cisco.bmp cisco.logo

4. Create a text file that will be used to build the ld or gk cfg file

-The file can be any name

-Must contain the upgradelogo key

-The SampleLogo.txt can be used as a template.

NOTE: the image number defined in step 3 must be used in this text file

5. Create the cfg file, use the cfgfmt.exe

-cfgfmt SampleLogo.txt lddefault.cfg

NOTE: if the same image is desired on all 7905's and 7912, use the lddefault.cfg and

gkdefault.cfg files.

6. Move the .logo file into the TFTPPATH directory

7. Move the lddefault.cfg or gkdefault.cfg) (attached) into the COUNTRY specific folder.

-The ld or gk cfg files will need to be in at least \TFTPPATH\United_States

NOTE: The cfg file will need to be copied to each COUNTRY directory supported by the CM.

8. Reboot the 7905 or 7912 for the new image to display

New Member

Re: changing 7912 ip phone displayed logo

Hi Jbarcena & everybody,

thank you for your sharing. Based on the steps 5 you mentioned .

5. Create the cfg file, use the cfgfmt.exe

-cfgfmt SampleLogo.txt lddefault.cfg

NOTE: if the same image is desired on all 7905's and 7912, use the lddefault.cfg and

gkdefault.cfg files.

Questions: Can we do as follows:-

cfgfmt SampleLogo.txt gk0011BB66DAD8.cfg , so that it pointed to the mac address?

thank you.

148
Views
8
Helpful
3
Replies
CreatePlease to create content