Changing an IP address on Unity 3.14 with Unified Messaging
We need to change the IP address on a Unity 3.14 Unified Messaging installation. When we attempted to do this after changing the address we could not get the avcsmgr service to restart. Any know issues with this or ideas on what we might be missing.
Re: Changing an IP address on Unity 3.14 with Unified Messaging
Check and make sure that your DNS does not have a static IP-Name address mapping. Flush the cache in your Unity server or to make sure that the cache is flushed, reboot the server.
From within the Unity server, ping the loopback and then ping the new assigned IP address. Is this new address ping-able from other devices? There is nothing specific to Unity when it comes to IP address changes.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...