I have a U 2.4.6 UM system that we have installed. I'm trying to figure out how to change the system default mailbox to use one of the subscriber mailboxes. I can't find documentation on how to do this. Can you point me in the right direction here?<br><br>
If you are referring to the default call handler (Opening Box), you can either program a subscriber (or DL) as the message recipient for this handler, or else you can enable the Alternate Greeting, set it to Blank, then set the after greeting action to Send to Greeting for your subscriber. This method would allow the subscriber to edit the greeting over the phone.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.