Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Changing DTMF to Out-of Band for ATA using SIP

How to change the AudioMode to get out-of-band DTMF?

The Audio Mode format: default format is 0x00150015.

Where 0015 0015 are the same audio settings for phone 1 and 2. My AS5300 "call history voice" shows a sipv2 call with inband DTMF.

"ATA parameters and settings" says:

bit 0 (mask 0x1): G.711SilenceSuppress: enable G.711 silent suppression (1)

bit 1 (mask 0x2): G.711Only: use G.711 only; do not use the low-bit-rate codec (0)

bit 2 (mask 0x4): FaxDetCED: enable fax CED tone detection (1)

bit 3 (mask 0x8): FaxDetCNG: enable fax CNG tone detection (0)

bits 4-5 (mask 0x30): DtmfMethod:

0=always inband (send and receive; don't send SDP info)

1=by negotiation (send SDP info, enable rcv, decode others SDP info, send depends on other SDP info)

2=always out-of-band (send SDP info, enable rcv, decode other SDP info, always send) (1)

any help would be appreciated

spencer

spencerw@dialdigital.com

1 REPLY
New Member

Re: Changing DTMF to Out-of Band for ATA using SIP

0x10151015 changes bits 4-5 to value "2" OR 10 in binary where 0001 0000 0001 0101 is the new setting

118
Views
0
Helpful
1
Replies
CreatePlease to create content