10-03-2007 05:57 PM - edited 03-13-2019 04:29 PM
HI we have CME and I was wondering if there was a way to change the sound that customers hear when they in dial? Currently it is a long ring with a pause and another long ring. Traditionally in Australia the in handset ringing sound is short and repetative?
Cheers
Barry
10-03-2007 06:38 PM
Hi Barry,
You can change this by changing the Network Locale. Network locales specify country-specific tones and cadences.In Cisco Unified CME 4.0 and later versions, you can install the files to support a particular user and network locale. That being said, I'm not sure what Locale would match the "Ringback Tone" you need as ther is no specific one for Ausralia :( You may have to experiment with this a bit.
Hope this helps!
Rob
10-04-2007 12:47 PM
Hmmm...I haven't check this specifically, but if you manage to adapt ringback, it could be by specifying a "cptone" under the voice-port. I assume you are using BRI or PRI.
hope this helps, please rate post if it does!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide