Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Changing in dial "in ear" ring sound

HI we have CME and I was wondering if there was a way to change the sound that customers hear when they in dial? Currently it is a long ring with a pause and another long ring. Traditionally in Australia the in handset ringing sound is short and repetative?

Cheers

Barry

2 REPLIES
Hall of Fame Super Red

Re: Changing in dial "in ear" ring sound

Hi Barry,

You can change this by changing the Network Locale. Network locales specify country-specific tones and cadences.In Cisco Unified CME 4.0 and later versions, you can install the files to support a particular user and network locale. That being said, I'm not sure what Locale would match the "Ringback Tone" you need as ther is no specific one for Ausralia :( You may have to experiment with this a bit.

http://www.cisco.com/en/US/products/sw/voicesw/ps4625/products_configuration_guide_chapter09186a00807d5536.html#wp1101867

Hope this helps!

Rob

Hall of Fame Super Gold

Re: Changing in dial "in ear" ring sound

Hmmm...I haven't check this specifically, but if you manage to adapt ringback, it could be by specifying a "cptone" under the voice-port. I assume you are using BRI or PRI.

hope this helps, please rate post if it does!

115
Views
0
Helpful
2
Replies