Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Bronze

Channelize a T1 in callmanager

Is it possible to channelize a T1 (Cas or PRI) in callmanager? I have a T1 with 24 ARD circuits, each channel has a unique ARD circuiton it. I need to configure plar for each indiviual channels.

1 REPLY
Bronze

Re: Channelize a T1 in callmanager

yes, possible with CAS, but I not possible with PRI unless you have a AS53xx. At any point, it depends with Telco.

Here's an example

controller T1 0/1/0

framing esf

linecode b8zs

ds0-group 1 timeslots 1 type fxo-loop-start

ds0-group 2 timeslots 2 type fxo-loop-start

ds0-group 3 timeslots 3 type fxo-loop-start

etc....

134
Views
0
Helpful
1
Replies
CreatePlease to create content