Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

check trunk utilization

which utility or tool can I check the T1 trunk utilization, from GW or CCM?

2 REPLIES
Bronze

Re: check trunk utilization

From CallManager, you can turn on your call detail records (CDR) and run reports on how busy it stays. Your telco can run reports as well. Probably the most accurate would be to setup some sort of management software (MRTG is free) and do SNMP queries over to the gateway.

Rick

Bronze

Re: check trunk utilization

From CM you can select Control Panel, Admin Tools, Permormance. Then use the (+) to set the Performance Object to Call Manager then add PRI Channels Active.

132
Views
4
Helpful
2
Replies