Hi, I'am using a CIPC registering on CCM 4.1. It is working well but each time I open the application a new window pops up to autoupdate. I alredy did the update but each time I open the CIPC it appears. How can I stop the autoupdate each time I open CIPC?
If you have previously enabled AutoUpdate for Cisco IP Communicator Release 1.x, you will need to disable it before upgrading to Cisco IP Communicator Release 2.0(1). To disable AutoUpdate, you must remove the load name assigned to the Cisco IP Communicator device in Cisco CallManager Administration. A blank entry means the device name has been removed. If you have installed Cisco IP Communicator Release 2.0 but have not changed the version information in Cisco CallManager Administration, then an Auto Update error may display:
Field Notice: FN - 62334 - Auto Update Not Supported From Cisco IP Communicator Release 1.x to 2.0
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...