06-25-2002 02:17 PM - edited 03-12-2019 07:26 PM
We have a VoIP Network with 2610 at the spoke locations.Every now and then few of the 2610 started loosing the E/M ports and everytime I need to restart the router again in order to make it to recognise the ports. The IOS is 12.1 Any suggestions.
06-25-2002 02:17 PM
Most likely you hit
a bug, try the latest image.
06-26-2002 05:53 AM
How do you "lose" the E&M? Does it disappear from "show ver" and "show diag"? If that is the case, then try to 1. reseat the cards by shutting router, reseat card in the NM-2V and reseating NM-2V in the 2610 slot, then reboot, and monitor 2. Capture any logs and errors that happens during the process.
---
If you lose network connectivity and actual calls on the E&M then it may be related to configuration, disconnect or hung ports, and you can see it by "show voice port summ" the IDLE state would be EM_ONHOOK...if it says EM_CONNECT when there is no call and no audio, reset the ports by shut/no shut and monitor "show voice port [port#]" status.
Running latest IOS image always is good idea. In your case, latest 12.1 mainline image would be 12.1.15.
Hope this helps.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide