Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco 2821 with NM-1CE1B module

Hi,

I have a question from my customer. They have a cisco 2821 with an NM-1CE1B module(PRI) and want to configure it as RAS for remote isdn users. Does the router need DSP/PVDM for this? As I am a voice guy I dont really know. I dont know if remote users are isdn or modems or a mix.

Any ideas.

Thansk

Mattias

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Gold

Re: Cisco 2821 with NM-1CE1B module

Correct.

As a recognition to contributors, please rate useful posts using the scrollbox below.

5 REPLIES
Hall of Fame Super Gold

Re: Cisco 2821 with NM-1CE1B module

The module alone supports data calls only, and in older router it was used together an NM-xDM to terminate modem calls. However the current technology of terminating modem calls on an ISR router is with a PVDM2-xDM module and HWIC-xCE1T1-PRI.

Hope this helps, please rate post if it does!

New Member

Re: Cisco 2821 with NM-1CE1B module

Thanks bevilacqua!

I guess then there is no need for DSP for ISDN data only.

Thanks

Hall of Fame Super Gold

Re: Cisco 2821 with NM-1CE1B module

Correct.

As a recognition to contributors, please rate useful posts using the scrollbox below.

New Member

Re: Cisco 2821 with NM-1CE1B module

Thanks,

5 points!!!!!

Hall of Fame Super Gold

Re: Cisco 2821 with NM-1CE1B module

Thank you for the nice rating and good luck!

284
Views
5
Helpful
5
Replies