Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Cisco 2851 and NEC Fusion 2600

I am designing a Call Manager system where the Call Manager servers and the gateway will be located in area A and the users in area b. the gateway in area a will a an e1 trunk to a NEC Fusion 2600 PBX . I was wandering if anyone has had any experience on this and if they have any pointers.

Thanks in advance

Paul

2 REPLIES
Silver

Re: Cisco 2851 and NEC Fusion 2600

The NEC Fusion protocol is implemented by the 5300, but not the 26/36. You have to use T-CCS with a 26/36 if you want to run NEC Fusion or NEC CCIS.

Community Member

Re: Cisco 2851 and NEC Fusion 2600

Hi

Thanks for the response. What is the T-CSS and is it compatible with a cisco router. I am using a cisco 2851XM router and an E1 PRI cable to connect the two. I have done something similar where the PABX sent DPNSS siganlling which we converted to QSIG using a westell converter and the sent it into a 2651XM using E1 PRI with QSIG signalling.

Thanks

300
Views
0
Helpful
2
Replies
CreatePlease to create content