10-11-2001 07:40 AM - edited 03-12-2019 12:52 PM
Hai,
We are trying a setup, on one end we have a cisco 3600 with 2 fxo ports connected to trunk line and other side we have a 2 fxs ports which are connected to phone instruments. We were able to configure for the incoming calls for one to one mapping, i.e If call lands on cisco 3600 port 1 it will be routed to 2600 port 1, if call lands on the port 2 it is mapped to port 2 of 2600 router.
But when we are trying to make out going calls from 2600 router it is picking up randomly on the cisco 3600 router, But we want port 1 should use port 1.
Can any body help me out.
Thanks in advance and regards
Sreenivas Reddy
10-11-2001 11:59 AM
Sounds like you should be using the connection trunk commands. See this URL:
http://www.cisco.com/warp/public/788/signalling/trunk_config.html
10-12-2001 05:20 AM
Hai Davgoodwin,
Thanks for your mail,
Do i need to implement plar on both the routers?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: