Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco 5400's Config

I config my 5400:

1 T1 for incoming call and 1 T1 for outgoing call. When I phoned 5400, I got fax-tone. My question is, can 5400 handle this kind of calls? If the answer is YES, can you give me a sample of the above about how to config 5400's dial-peer and translation-rule?

  • Other Collaboration Voice and Video Subjects
1 REPLY

Re: Cisco 5400's Config

You need to be sure to configure an explict inbound pots dial peer. Unlike other platforms, calls that do not have a dialpeer are treated as modem calls rather than voice.

There is no "default" dial-peer.

For example:

dial-peer voice 10 pots

incoming called-number .

direct-inward-dial

HTH,

Michael

PS: please remember to rate posts!

103
Views
0
Helpful
1
Replies
This widget could not be displayed.