I'm having problem with getting C7960 to work behind NAT. I've got 8.4(0) software and NAT configured on C1600 router with IOS 12.3(20).
I've nat_enable: 1 and other nat connected options enabled on the phone, nat address is set to outside address. I've three SIP operators configured, I got two of them registered on its proxies. I could place and receive calls, but with no voice. I've tried different codecs and even Linksys WRT54G router instead of C1600. No effect.
Voice gateways from Linksys works perfectly behind that NAT. I've made ip nat inside source static entries for every required port.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...