I have a Cisco ACS server for AAA. My gateway router is setup on it as a TACACS+ Cisco IOS Hosts. The router has aaa commands
aaa authentication login default group tacacs+ local
aaa authentication login LOCAL local none
aaa authentication enable default group tacacs+ enable
aaa authorization commands 15 default group tacacs+ if-authenticated
aaa accounting commands 15 default start-stop group tacacs+
aaa accounting network h323 start-stop group tacacs+
aaa accounting connection default start-stop group tacacs+
aaa accounting connection h323 start-stop group tacacs+
i get voip logging in the TACACS+ accounting reports. But these are very time consuming to parse out call logging info. Do i need to change my gateway router to a radius host and change the aaa authentication and accounting commands to have the voip log in the voip and radius accounting reports on the ACS server?
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...