Site 1 PSTN E1----VG----Call Manager----VG--- PABX---Site 2 PSTN1 E1
I have configured a dialing pattern on Cisco call manager 6.xxxxxx to Send to VG on Site1
Both VG routers are using MGCP with call Manager.
The problem if from Site 2 tries to call 6xxxxxx the call manager is not routing the call to the VG in site 1.
I did debug ccapi inout and on Site 2 VG the call response was the number unassigned. This means that the call Manager is searching the directory for the destination but it is not searching the route patterns.
Any ideas to override this and ask the call manager to check it's destination pattern?
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...