Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Cisco Call Manager Expres configuration.

Hi all,

could someone help me how

should I configure dial plan on CCME?

If it is possible could someone send me

basic configuration of router or help me

conf. on router which function with CCME.? You know I want to configure users to call outside through E1 or BRI so where should I configure routing of

calls going outside and inside too to reach every destination outside and inside.?

BR

jl

5 REPLIES
Community Member

Re: Cisco Call Manager Expres configuration.

Hi

Try to use the "CME Quick Config Tool"

http://www.cisco.com/cgi-bin/tablebuild.pl/cme-qct

It makes a quite ok configuration to modify.

I tryed it, it was not able to communicate with my 2811, but i just pasted the parts of the conf i would use.

/Per

Community Member

Re: Cisco Call Manager Expres configuration.

Thanks really for url and advice.

Iv downloaded this tool successfully.

Is over there any possibility to configure

dial plan for calls outside for instance through

BRI or PRI on router.?

BR

jl

Community Member

Re: Cisco Call Manager Expres configuration.

Hi

Just run the tool.

Tell it which interfaces you have in the router

It makes a fully functioning standard conf with DID and 9 to access outside line.

Is it a wery special configuration you want ?

/Per

Community Member

Re: Cisco Call Manager Expres configuration.

Hi,

I dont know if it is special conf. but

I want to use two and more separate BRIs

instaled insde router and in the future convert it to

PRI. Number of users will be up to 90. In the future

I want to convert it to SRST (because it is branch) and do CCM centrally.I think it is standard

step from nothing to future spread of IP telephony

around company.

And now I dont know how should I do this to route

calls throuhg more separate BRIs in the same router.

BR

jl

Community Member

Re: Cisco Call Manager Expres configuration.

Hi

No problem, QCT vill make it for you.

It's just a simple dial-peer on all the isdn interfaces.

Like this (asuming 0 is used to get an outside line)

dial-peer voice 2 pots

destination-pattern 0T

port 0/0/0

/Per

134
Views
0
Helpful
5
Replies
CreatePlease to create content