I have a PRI integration BTW Cisco CallManager and Mitel. We have two sites, one in New York and one in Jersy city. We can call New York (Cisco to Mitel)without any problem, but from New York to Jersy City (Mitel to Cisco) we lose 3 digits. When I dial 3566 from mitel phone I receive only the last digit which is 6 in my debug q931 output in Jersy City. Mitel Engineer sees in his system that he is sending me 4 digites but I receive only 1 digit. We lose 3 digits somewhere on the way from Mitel to Cisco. I am including the Gateway configuration both in the router and CallManager. Could you please review the config and let me know if I am doing anything wrong in my side (Cisco)?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...