Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Cisco CallManager ver 5.0(4) installation problem

Dear Sir,

I have installed Cisco CallManager ver 5.0(4) at server 7815-i (IBM) using Cisco Unified CallManager Installation Disk but when i have finished the installation & the system reboots, the server asks for login name & password, i have entered them correctly then the system displays the following prompt

welcome to the platform command line interface (version 1.1)

admin :

please advise

4 REPLIES
Hall of Fame Super Red

Re: Cisco CallManager ver 5.0(4) installation problem

Hi Derar,

Have a look at the following docs (especially the CLI commands). We don't use 5.0.4 so I can't test;

Log Into Cisco Unified Communications Operating System Administration

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00806c3e28.html

Cisco Unified Communications Operating System Administration Guide, Release 5.0(4)

Command Line Interface

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00806c3e25.html

It just looks like you have accessed the CLI rather than the GUI.

Hope this helps!

Rob

Please remember to rate helpful posts.....

New Member

Re: Cisco CallManager ver 5.0(4) installation problem

What els do you want ??

U have compeletly installed cisco unified CallManager ,

Try to See the welcome screen by typing your server IP address in a browser.

Administrator user is CCM followed by (the username you entered during installation )

For example if I enter "Administrator" my username to log into CallManager administration page will be "CCMAdministrator"

for OS administration and disaster recovery u dont need to have that CCM before your username

you can change all these in User managment section of CCM Administrator page

New Member

Re: Cisco CallManager ver 5.0(4) installation problem

Thanks,

i have accessed the device through web fro another PC,

but can i do that from the CallManager server itself..

Best regatrds

Hall of Fame Super Red

Re: Cisco CallManager ver 5.0(4) installation problem

Hi Derar,

Browsing to Cisco CallManager Administration

You access the Cisco CallManager Administration program from a PC that is not the web server or has Cisco CallManager installed. No browser software exists on the server.

From this doc;

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_administration_guide_chapter09186a00806b1225.html#wp1022592

Hope this helps!

Rob

Please remember to rate helpful posts.....

175
Views
0
Helpful
4
Replies