Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
376
Views
0
Helpful
1
Replies

Cisco CME to SIP Proxy

chris.moore
Level 1
Level 1

‎05-03-2007 03:35 PM - edited ‎03-13-2019 04:07 PM

Hello, I have two 7940 phones running SCCP with CME 3.3 on a 2611XM Router. I'm trying to use my SIP phone number for the primary phone number using the SIP-UA in CME. So far the SIP-UA is registered and I can dial the sip number and both phones ring, but my problem is that I cant dial out from any phone. I have tried a few different dial-peers but i still cant dial out. Any help would be greatly appreciated. Thankyou. Chris.

Labels:
0 Helpful
1 Reply 1

paolo bevilacqua
Hall of Fame
Hall of Fame

‎05-04-2007 12:45 AM

Hi Chris,

to which SIP proxy are you connecting ? Most likely they want authentication, have you configured that under sip-ua ?

Please enable "term mon" and "debug ccsip message" for a failed call and that will tell you what is going wrong.

Hope this helps, please rate post if it does!

0 Helpful
Customers Also Viewed These Support Documents