Explanation: NonTimeout error occurred during call to recvfrom().
Recommended Action: Ensure your system is connected to the
network. Check windows Taskmanager to make sure TFTP is getting
time to serve files. Make sure you are following configuration guide
recommendations for your system configuration..
This error is occuring quite frequently and does not seem to be having any affect on the performance of the installation. This is on a publisher running 3.1(4b) Serv pack D in a cluster with 2 subscribers.
Any help/advice on this would be greatly appreciated.
Thanks for the reply, I did try this but it proved unsuccessful. However, I have since found that the problem seems related to a hardware conference bridge resource that is no longer registered to the pud due to a faulty switch port. I am waiting a swap out of the cat blade to confirm.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...