I was doing a new installation of Unity 3.1(5) and had gotten through almost all of the steps. I had just run Unity Setup and was about to run the Configuration Wizard. After being prompted and selection Exchange 2000 as the Message store (Unity and Exchange are on the same box), I get an error message saying that "Cisco has failed to update the schema".
I am assuming that something went wrong with the AD install but I got no errors in the application log. Do I need to edit my registry settings? Has anyone come across this message before?
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...