As I've read in Cisco announcements, Cisco and Vocaltec products are compatible, so I wonder how it's possible to register Vocaltec surf'n'call clients to Cisco gatekeeper, having them send calls via Cisco gateways.
Please note that Surfncall uses some ID/URL authentication with gatekeeper.
Re: Cisco gateway/gatekeeper and Vocaltec Surf n Call
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
IntroductionCUCM Routing RulesDial String implementation PolicyCUCM Routing LogicSIP URI Call Routing Analysis+++ Case Study: 1 ++++++ Case Study: 2 +++Conclusion
Over the last few months, I have had the privilege of working on SI...
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...