Has anyone configured a cisco GW (with a nm-hdv-1e1-30e) to work througth the E1 with a MATRA PBX. We are not sure about the parameters you have to configure at the PBX. We are using "isdn primary-net5" and the router is the user side. We have problem when we try to place a call to an external destination throught the PBX.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.