Are you using call manager? If so just go to devices/phones/ add a new phone and choose ata186. I have to tell you I had a lot of problems with older fax machines and the ata's. The problems I experienced were having to do with fxo disconnect. The user would receive a fax and there would be no disconnect so any other faxes would here a busy signal. As for the Germany parameter I am not to sure on that. Hope this helps.
the problem is now resolved, the ATA have a similar config as an 7960 in the ITS enviroment. I have to configure a new e-phone and put the mac adress form the ATA in, then I have to configute button 1:
We have developed some applications for ITS including a Voicemail system, a software for billing, a contact manager and much more. You can find these products on the website www.stonevoice.com, which is the BU we have created for developing software for IP Telephony. But we have also created other applications customized for specific customers (network monitoring software with ITS support, etc...) and keep on creating new apps.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.