Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cisco to Lucent

We have a 3640 that connects to a Lucent Merlin PBX

using E&M signaling. We are migrating all people from Lucent to AVVID.

The Problem is every time we make a phone call from

the IP phones we have 50/50 chance of getting a busy signal, we hang up and try again it dials with out any problems.

Have anyone experienced this.

Thanks,

6 REPLIES
New Member

Re: Cisco to Lucent

Post or email your 3640 configuration...

mschlenger@n2nsolutions.com

New Member

Re: Cisco to Lucent

I've experienced a simalar problem using e&m wink-start signaling. I resolved it by changing the singaling to e&m immediate-start.

New Member

Re: Cisco to Lucent

I tried and it didn't work. Also all the IP phones was unable to receive calls once I made the change. Here is my Controller config:

controller T1 3/0

framing esf

linecode b8zs

cablelength short 133

ds0-group 1 timeslots 1-16 type e&m-wink-start

New Member

Re: Cisco to Lucent

Please post your voip and pots dial peers...

New Member

Re: Cisco to Lucent

voice-port 3/0:1

!

dial-peer cor custom

!

!

!

dial-peer voice 2 voip

destination-pattern 3...

session target ipv4:10.1.1.2

dtmf-relay h245-alphanumeric

codec g711ulaw

!

dial-peer voice 1 pots

destination-pattern 9

port 3/0:1

prefix 9

New Member

Re: Cisco to Lucent

That dial peer looks as if it may be missing wildcard digits .... not exactly sure what PBX extensions you are trying to dial. Your voip and controller look ok so I doubt thats the problem. You may have to adjust your wink parameters if you can't resolve this. I'd recommend calling TAC to expedite the fix. Can you post your results?

138
Views
0
Helpful
6
Replies
CreatePlease login to create content