Is there anyway to keep the CiscoIPPhoneStatus "on" while calling? When I tried it only hovers when I'm off the call. As soon as I pick up the phone the CiscoIPPhoneStatus goes away. Is there any solution to this?
You could try changing what is called the "timer seed value" within its Object XML. This is a timer based in seconds on how long the object is displayed after it is triggered. However, the 'hovering' in the Call plane, rather than the Services plane is by design, so I am not sure you can do much with this Object, including closing it out or clearing it by pressing Services. Here is a Development reference link with this explanation in more detail:
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...