Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

CiscoOS and CM Installation w/o network

Hi,

Can any problem to occur while-and-after I'm installing Cisco OS and CallManager 4.2(3)

on the MCS that currently doesn't have network connection (no network cable plugged into

the MCS's NIC1).

When I'm writing the word 'problem', I mean the influence might take place

for finally installed Cisco OS and CallManager configuration, i.e. the unpleasant

things could be avoided, if I install the Cisco OS and CM while MCS is connecting to

the corporate net ?

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: CiscoOS and CM Installation w/o network

Hi Tobivan,

Hope all is well!

We just did an exact CCM 4.2(3) build in the lab (not connected to the Campus Network) before going live without any issues :) You will want to to connect to a lab switch, especially for building any Subscriber boxes (db replication) but other than that you should be good to go.

Hope this helps!

Rob

3 REPLIES
Hall of Fame Super Red

Re: CiscoOS and CM Installation w/o network

Hi Tobivan,

Hope all is well!

We just did an exact CCM 4.2(3) build in the lab (not connected to the Campus Network) before going live without any issues :) You will want to to connect to a lab switch, especially for building any Subscriber boxes (db replication) but other than that you should be good to go.

Hope this helps!

Rob

New Member

Re: CiscoOS and CM Installation w/o network

Thank you, Rob.

I've actually checked this today. All is fine.

Hall of Fame Super Red

Re: CiscoOS and CM Installation w/o network

Hi Tobivan,

You are most welcome my friend :) Glad to know this didn't cause you any problems either.

Take care,

Rob

194
Views
0
Helpful
3
Replies