Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CLID from DialPeer on H.323 Gateway?

I tryed to link our old PBX with CCM. I use FXO port on C1750 and wrote dial-peer

with destination pattern 1234... (we use last three digits as lines on PBX). All works fine.

But when I calling from PBX to IP phone on CCM, I see 'Unknown caller number...'. I would like to see somethink better, somethink like 1234111 (operator's number).

How to do that?

7 REPLIES
Gold

Re: CLID from DialPeer on H.323 Gateway?

I think that you have to change the 'UnknownCallerIdText' parameter, in the Service Parameters section, with the value that you would like. I expect that this thing could help you.

Juan Luis Lopez Calabuig

New Member

Re: CLID from DialPeer on H.323 Gateway?

Yes, but it will change text globaly for all unknown calls. But I have two gateways with diferent sources. So I need somethink "smarter". Thanks

Bronze

Re: CLID from DialPeer on H.323 Gateway?

Try putting the command:

station-id number 1234111

under the voice-port configuration.

-Dustin

Silver

Re: CLID from DialPeer on H.323 Gateway?

Under the POTS dial peer that references the physical voice port, add the following:

dial-peer voice 1 pots

destination-pattern 1234...

port 1/0/0

answer address 1234111 <-------- add this

The router will use the answer address of 1234111as the calling number for all inwards (POTS to VOIP) calls.

Just be aware that all calls that come through this port will use the configured answer address.

New Member

Re: CLID from DialPeer on H.323 Gateway?

Thanks, it works.

Is there any option to specify text part of CLID message? In some cases may be usefull to specify not number, but text. Ex. 'cellular gateway call' or something like it.

Silver

Re: CLID from DialPeer on H.323 Gateway?

I just tried adding 'station id name voiceport1/0/0' on the voice port config and ran a H225 asn1 debug and saw the following :

!

voice-port 1/0/0

station-id name VoicePort1/0/0

!

1d01h: H225 NONSTD OUTGOING PDU ::=

value ARQnonStandardInfo ::=

{

sourceAlias

{

}

sourceExtAlias

{

}

displayInformationElement "VoicePort1/0/0"

interfaceSpecificBillingId "FXS 1/0/0"

}

this suggests it is being sent out in the H225 signalling, so it may work, just depends if the CM will do anything with the information or not.

New Member

Re: CLID from DialPeer on H.323 Gateway?

Thanks it works. But to see 'station-id name' you have to set 'station-id number' too.

258
Views
0
Helpful
7
Replies
CreatePlease to create content