Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

CLID Name with Number

I have a customer that has a 3.0.11 Callmanager cluster, a Catalyst 4604 Gateway and a PRI. What needs to be done to get the Caller ID name and number to show up on the IP phones? Currently, only the number appears. Thanks in advance.

6 REPLIES
New Member

Re: CLID Name with Number

NI3

New Member

Re: CLID Name with Number

Huh?

New Member

Re: CLID Name with Number

I think what jrarrons is trying to say is that PRI does not support name on CLID yet. NI3 (National 3 signalling) is supposed to support it, whenever it is available.

Bronze

Re: CLID Name with Number

PRI does support CLID Display, you need to make sure that the Calling Party name is sent in a Display IE, CallManager will not accept any other message for Calling Party name display.

Make sure the Presenataiont Bit is set to allowed, and the Display IE checkbox is checked under the gateway configuration.

-Dustin

New Member

Re: CLID Name with Number

Thanks, I'll give that a shot.

Cisco Employee

Re: CLID Name with Number

Do a debug isdn q931 on the 4604 gateway and see if you are getting the Display i.e. from the telco. If you are not getting it from the telco you will not see it on the IP phone. Sometimes telcos forget to turn the feature on.

If you are not sure about the debug isdn q931 post the results and someone should be able to help you.

You do not need ni3 to get callerid.

Thank you,

-Mckee

122
Views
0
Helpful
6
Replies
CreatePlease to create content