When a user is on thier first line on 7940 and they get another call, CLID does no show up for that call. Before upgrading to 3.1(3a), it would say from XXXXXXXX at the bottom of the phone. Anyone else having this problem?
I am not sure. I would have to look at a ccm trace to see if the CCM was sending the info to the phone or not. If the CCM is sending it and phone is not displaying it is a phone load issue. I can try to see this up in the lab and see. The bug descriptions do not have this info in them. They just say it stopped working. You could do a quick test with one of your phones and change the load back to the default load for 3.1(2c) and see if it works or not. That seems like it would tell you if it was the phone load or not. Just go to the phone and set the load information to "P00303010102" with out the quotes. Update the phone and reset it and see if it works. Please make sure you have this load in c:\program files\cisco\tftppath. If you were on 3.1(2c) it should be there. You can do this just for a test. Let me know the results. I can also test this in my lab on Monday.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.