Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Client Matter Code

I am using a call manager 6.1. I am using Client Matter Code as the authorisation code for a particular partition. The problem I am facing is that, the code is visible when I press the code for initiating a call. Is there any way that I can make this masked (astrik) when the code is pressed.

1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Red

Re: Client Matter Code

Hi Alex,

Sadly, this is not possible when using CMC's. The use of CMC's is really meant for Billing/Chargeback type scenarios like in Law Firms when calls relating to a certain file or case should be Billed against that Client via CMC Codes. When you want to Authorize calls via a PIN type code entered by the user, the recommendation is to use FAC's (Forced Auth Codes). When these are entered the Digits "are" hidden :)

Hope this helps!

Rob

1 REPLY
Hall of Fame Super Red

Re: Client Matter Code

Hi Alex,

Sadly, this is not possible when using CMC's. The use of CMC's is really meant for Billing/Chargeback type scenarios like in Law Firms when calls relating to a certain file or case should be Billed against that Client via CMC Codes. When you want to Authorize calls via a PIN type code entered by the user, the recommendation is to use FAC's (Forced Auth Codes). When these are entered the Digits "are" hidden :)

Hope this helps!

Rob

287
Views
5
Helpful
1
Replies