previously (Conversation title: How to set CLIR on ISDN?)I have asked about enabling CLIR on PRI for AS5300. As I found out the CLIR is an option in 'setup message' on ISDN signalling level. In our county we are currently using DSS1 protocol, so I need to find how to manage DSS1 'setup message options' from Cisco CLI. Anybody can help with it?
Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...