03-05-2002 02:27 PM - edited 03-12-2019 02:41 PM
I have a a question about T1 clocking.
I have a 2620 router w/ a WIC T1 module connecting to a data T1 and a NM-1V w/ a VIC-1MFT1 going into a PBX. The WIC has clocking set for internal and is connected via a PPP line to another 2620 w/ clocking set to line. The 2620 on the far end is connected to a PBX also.
The issue is the voice line doesn't come up. The PBX is providing clocking at both ends to the VWIC. Can I set the VWIC at the near end to clocking line with the WIC set to clocking internal?
03-11-2002 10:17 AM
Often times complex troubleshooting issues are best addressed in an interactive session with one of our trained technical assistance engineers. While other forum users may be able to help, its often difficult to do so for this type of issue.
To utilize the resources at our Technical Assistance Center, please visit http://www.cisco.com/tac and to open a case with one of our TAC engineers, visit http://www.cisco.com/tac/caseopen
If anyone else in the forum has some advice, please reply to this thread.
Thank you for posting.
03-14-2002 10:39 AM
When you say the voiceline doesn't come what, what line is that? The PBX-2620? Also, do you mean that the T1 interface shows down when you do a show interface?
03-14-2002 11:15 AM
Thanks for replying, although it ended up being the PBX. It wasn't configured correctly on the other side, only the people over there didn't realize it. Thanks again though.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide