Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Cluster Over WAN Test

We are planning to put a subscriber across WAN.We have enough bandwidth (6MB) bewteen sites and we followed all the SRND recommendations(especially QOS) for Cluster over WAN.

I used extended ping with type 3 (as in SRND) to test the RTT from a switch at remote site to publisher CM and it came less then 40 ms.

Is there any other test we can do so we can test the RTT and bandwidth is enough for ICCS traffic.

Thanks for the help

Bala

1 REPLY
Blue

Re: Cluster Over WAN Test

you could put a good load of data on the wire across the wan, see if you can get 3-4mb (or whatever your maximum is) and then test your pings.

use the results added to the number of phones (BHCA) and see what the numbers 'should' look like.

be sure to use the bandwidth calculator if you haven't already. try for many or all different codecs.

see the bandwidth calculator at the following link: (requires cco account)

http://tools.cisco.com/Support/VBC/do/CodecCalc1.do

127
Views
0
Helpful
1
Replies
CreatePlease login to create content