CM 3.2 upgrade stopped Unity Standard Greetings on "Virtual" phones
We created 30 line templates for virtual phones. We use made up MAC addresses, AABBCCDDEE..., and assign all of our unused lines to these phones. Then we have the lines fowarded to a general menu. This stops the routing loops between our traditional PBXes and our Gateways/CallManagers. We have several department menus set up on Unity with some of these virtual lines. The standard greetings on virtual phones stopped working when we upgraded to CM3.2. We can foward calls to virtual phones and from virtual phones but cannot foward all calls to voicemail on virtual phones and get the standard greeting. Instead, we get the prompt for password. Has anyone else encountered this and found a workaround
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.