Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CM 4.1 2811_MGCP NO 5ess switch type in GW PAGE

Hi,

We have a T1 PRI installed for voice and we wanted to use MGCP. The switch type is primary-5ess

The issues is in CM there is no 5ess switch type to select is there another that will work.

Thanks

2 REPLIES
Silver

Re: CM 4.1 2811_MGCP NO 5ess switch type in GW PAGE

Configure the isdn switch type on the 2811 and that will take precedence.

Regards

New Member

Re: CM 4.1 2811_MGCP NO 5ess switch type in GW PAGE

Thanks I had it set for 4ess on CM and it worked.

So basically for a for a vwic-MFT T1 and MGCP in CM

the switch type doesnt appply. Would this be correct.

125
Views
4
Helpful
2
Replies