I would like to change the access code when user dial out to PSTN, for example, 001-852-1878200 need to be convert to 1591-852-1878200. I set the Called Party Transform Mask to 1591 in translation pattern, but it doesn't work. Did I miss other configurations?
You should now have a route pattern(s) that include the 001 access code. You will need to change these to 1591 and make sure that the code is being stripped. Feel free to post your route pattern config if you would like additional help.
OK. So, you'll need to do digit stripping on CCM and there will not be a dial peer to change on the gateway. You could make your route pattern 91591.! and change Discard Digits to PreDot. This would strip 91591 and send everything else to the PSTN.
I think the Prefix digit in the Translation pattern 9.00! should be 9.1591 instead of just 1591. Also in the route pattern 9.1591, set Discard Digits to "Pre-dot" for Called Party Transformation. Everything else remains.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...