Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Users might experience few discrepancies in Search results. We are working on this on our side. We apologize for the inconvenience it may have caused.
New Member

CM Administration problem-newbie question

I'm terribly sorry for a silly question, but I have installed CUCM 6.01 under VMware and have created Administration username/password (I was aked to create one during the installation process). When I try that combination on CM Administration page, it gives me:

"Non defined IMS Exception".

Does anyone knows what seems to be a problem?

Many thanks in advance, Alex

1 ACCEPTED SOLUTION

Accepted Solutions
kmr
New Member
8 REPLIES

Re: CM Administration problem-newbie question

It sounds like a Java error to me. Have you updated your java client?

-brad

www.ccbootcamp.com

(please rate the post if this helps!)

New Member

Re: CM Administration problem-newbie question

Hi,

Following your advice, I have updated to JRE 1.6.0.3, but the error still exists.

Regards, Alex

kmr
New Member

Re: CM Administration problem-newbie question

New Member

Re: CM Administration problem-newbie question

I started to wonder if I'm the only one receiving this message...

Cross my fingers :-)

kmr
New Member
New Member

Re: CM Administration problem-newbie question

Dear kmr,

Many thanks for your post, since it has solved my problem !!!!

Now I can proceed further, finally.

Regards, Alex

kmr
New Member

Re: CM Administration problem-newbie question

Curious... which method worked for you, the CLI reset password or verification of LDAP params in CUCM?

New Member

Re: CM Administration problem-newbie question

Dear kmr,

I tried CLI only and it was enough:

(admin: utils reset_ui_administrator_password)

Afterwards, I was able to logon normally to CM Administration page.

Regards, Alex

234
Views
0
Helpful
8
Replies
CreatePlease to create content