In some documentation Cisco maintains that you should have at least a 10Mbps link between CallManagers in the same cluster. This rule was probably made to be excessively conservative (not a bad thing).
You should also keep in mind that there are two types of data other than SQL database data shared by CallManagers in a cluster, LDAP (DC Directory) and runtime data (CallManager-to-CallManager over SDL). A remotely located CallManager that is part of the local cluster might generate respectable amount of traffic if it had 2500 registered and relatively busy phones
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...