Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

CM joins domain, DC Directory will not start

When a CM 3.2(2c) is joined to a domain (is currently a workgroup member) and reloaded, the DC Directory service will not start, however the CM continues to function ok. The only resolution at this time is to revert to a backup disk.

2 REPLIES
Bronze

Re: CM joins domain, DC Directory will not start

what do you mean "reloaded"? rebooted? Are you also using the AD connector?

geoff

New Member

Re: CM joins domain, DC Directory will not start

sorry, I was a bit vague. When the CM is joined to the domain, it says it has to be rebooted. The the CM has restarted, the DC directory reports an error in the event log stating that the directory was shutdown abnormally without journalling enabled, and that it should be restored from a backup.

The CM does not have the AD connector installed.

84
Views
0
Helpful
2
Replies