I get the following error in event viewer on the CM. WDPSD is a route list that points to a route group that has a h323gateway. It is the main PRI for all incoming/outgoing calls. I can ping the gateway from the CM no problem. The gateway has never failed. ??
Error: RouteListExhausted - An available route not found in the indicated route list.
App ID: Cisco CallManager
Cluster ID: WDPCCM01-Cluster
Node ID: 10.115.1.1
Explanation: An available route could not be found in the indicated route list.
Recommended Action: Add additional routes in the indicated route list. This alarm indicates a network failure or device failure..
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.