I am familiar with building a device, route group, route list, for a gateway, but we are connecting a CM5.0 to a SIP proxy via a SIP TRUNK. Inbound calls work fine, but I cannot get the outbound dial plan configured to pass calls to the SIP trunk. Any suggestions - examples?
If I leave the CSS partitions off of the phone, the inbound calls over the SIP trunk work fine.
The route pattern / translation patterns appear to let me dial all of the digits.
What bothers me, is I cannot create a Route Group or Route List. When I attempt to create the Route Group, there are no available devices in the drop down list. I do not know if this is a CCM 5.0 issue, or if this is a SIP trunk issue. When I built one to a router MGCP gateway on another CCM, the route group was built to the gateway, and the route list accordingly. I am unable to build either on the 5.0.
I'm not able to access my old voice mail messages all of a sudden. The recording says something like 'the message is currently not available'. This has never happened before in all the years I have been using this system. I have t...
If you have 2 ISR routers, one acting as Failover, do we need to have both the same number of SRST licenses on the 2 routers?
No. You will only need the SRST licenses on the primary router. Because this feature...
You have reached the Cisco Logistics Support Center.. To Check Status of your RMA, visit Product Returns & Replacements (RMA).
Need help? Contact us by Phone or Email.
Phone: 1800 553 2447 Option 4